Step 1 start in a doorway or corner of the room.
Removing carpet nails from hardwood.
Before you can begin to deep clean hardwood floors you will need to remove the stubborn adhesive that was left behind you might also still have some remnants of your carpet tacks and staples still on the ground that need removing.
Use your standard screwdriver to pry them from the floor.
On a concrete floor the carpet pad is often glued into place.
Use pliers to pull padding staples when removing carpet from stairs.
Step 2 locate the brad nails that hold the first piece of tack strip to the floor.
If you ve pulled up an old carpet to reveal a hardwood floor there s a good chance the floor will need some level of repair.
Remove the carpet tacking strips which may be nailed or stapled to the hardwood floor.
Remove all of the leftover residue.
This needs to be removed.
In this case use a floor scraper to remove the pieces of padding that remain stuck to the floor.
Locate a nail head on top of the tack strip.
If the old carpet was installed over a hardwood floor that you now want to restore slide a wide putty knife between the tack strip and the floor.
Removing old carpeting may be necessary to save labor costs if you are having your carpet replaced.
Tough spots might require a power oscillating tool.
With a few common tools you can have the job finished in an afternoon and enjoy your new hardwood floor.
The procedure for removal of both these adhesives is the same but the products used are not.
After pulling up your carpet you will most likely have tack strips left around the perimeter of the room.
In order to have that beautiful hardwood floor you need to keep in mind that there are two types of glues that are used when putting down a carpet general carpet adhesive and tar based glue.
Joe is still working on his carpet removal project it s now.
Use the pliers to pull up any staples that remain stuck in the floor.
You ll be relieved to learn it s a straightforward task to remove carpet tack strips from hardwood floors.